The Dimplex infra-red wall heater is a safe & practical source of heat in bathrooms, kitchens, work areas - anywhere where fast localised heating is required.
The heater has a selection of two power outputs, 600W and 1200W, switched via an inegrated pull cord. It is designed to provide rapid beamed warmth and has an adjustable beam angle to direct heat where it is most needed.
Model IRX60/120E Power 600W or 1200W. Voltage 230V.
Drip proof protection (IP24 rated).
Dimensions: L764 x H100 x D92
General note about heaters in bathroomsMounting height is generally accepted to be a minimum of 1800mm from the floor. A gap of 300mm should be left either side of the heater. There are no regulations regarding distance above the heater from the ceiling but we advise gap of at least 250mm . This gap may vary depending upon the type of material used in the construction of the ceiling above. Some manufactuers recommend a minimum of 400mm above the heater to the ceiling but this make installation impossible in some modern homes with low ceilings. If in doubt consult an electrician before purchasing.
- Holiday chalets
- Garages and Workshops
- Utility rooms
- Additional Information
upc No length No width No height No Manufacturer No